Pin-out info from the 4’x4′ table with dual C10 breakout boards

Board 1 – Controls the stepper motors and handles the THC, Float Switch and E stop.

Jumper Settings

Comm Jumper set to 5V

Pins 2-9 Jumper set to Outputs

Input Jumper set to Pull Down

  • Pin 1 –
  • Pin 2 – X Step
  • Pin 3 – X Direction
  • Pin 4 – Y Step
  • Pin 5 – Y direction
  • Pin 6 – Z Step
  • Pin 7 – Z Direction
  • Pin 8 – Y Step (Second Motor on Y Axis)
  • Pin 9 – Y Direction ( Second Motor on Y Axis)
  • Pin 10 – Floating Torch Switch Input
  • Pin 11 –  Arc OK Input
  • Pin 12 – THC Move Down Signal Input
  • Pin 13 – THC Move Up Signal Input
  • Pin 14 – Torch On Output (To relay board)
  • Pin 15 – Estop Signal In
  • Pin 16 –
  • Pin 17 –

Board 2 – Only handles Home/Limit Switches for now

Jumper Settings

Comm Jumper set to 5v

Pins 2-9 Jumper set to Inputs

Input Jumper set to Pull Up

  • Pin 1 –
  • Pin 2 – Y2 Axis Home and Limit
  • Pin 3 – X Axis Home and Limit
  • Pin 4 – Z Axis Home
  • Pin 5 – Y1 Home and Limit
  • Pin 6 –
  • Pin 7 –
  • Pin 8 –
  • Pin 9 –
  • Pin 10 –
  • Pin 11 –
  • Pin 12 –
  • Pin 13 –
  • Pin 14 –
  • Pin 15 –
  • Pin 16 –
  • Pin 17 –